Henny Penny HHC-993 - Manual (Page 20)

Model HHC-990
4-3. SPECIAL PROGRAMMING This mode allows you to program the following:
SP-1 • Fahrenheit/celsius
SP-2 • Lock/unlock
SP-3 • Air temperature setpoint
SP-4 • Humidity setpoint
SP-5 • Proof air temperature
SP-6 • Proof humidity setpoint
SP-7 • Out of water tripp point
SP-8 • Clean water pan setpoint
SP-9 • System intialization
SP-10 • Audio volume
SP-11 • Audio tone
SP-12 • Audio effects
SP-13 • Language options
SP-1 Fahrenheit/Celsius 1. Press and hold the until “LEVEL 2”, then “CLOCK SET”
shows in the display.
2. Press again, then “SP PROG” shows in display.
3. After 5 seconds, “ENTER CODE” shows in display.
4. Press and “SP-1, TEMP, UNITS” and
“ o F”or “o C” shows in the display.
5. Press the to change temperature units.
SP-2 Lock/Unlock 6. Press and “SP-2, LOCK/UNLOCK PROGRAMMING’
shows in display, along with either “LOCK” or “UNLOCK”.
7. Press to change lock the programming or unlock the
programming.
SP-3 Air Temperature Setpoint 8. Press and “SP-3, AIRTEMP SETPOINT,” and the
preset cabinet temperature shows in display.
9. Press to change the air temperature setpoint,
140 o F (60 o C) minimum, 210 o F (99 o C) maximum.
303 4-3