Hayter Mowers Harrier 48 48ST - Manual (Page 27)

485101MT210999A
WARNING - PREVENT ACCIDENTS: Stop the engine
and disconnect the spark plug lead before attempting to
carry out maintenance procedures on the mower.
Engine Cowl
Carburettor
Spark Plug / Lead
Muffler Guard
Muffler
Oil filler Cap/ Dipstick
Start Grip
Fuel Cap
Finger Guard
Air Cleaner
Remove two screws securing the engine cowl and remove
the cowl to expose the throttle mechanism on the front of the
engine. Loosen the outer cable clamp screw (1) and move
the governor control lever (2) to the left as far as possible.
Insert a large, flat blade screw driver (3) into the slot in the
engine control bracket (4) at the angle shown. Push the gov-
ernor control lever to the right until it just touches the screw
driver blade. Move the throttle control lever to the ‘fast’
position (not the ‘choke’ position) and re-tighten the outer
cable clamp screw. Replace the engine cowl.
MAINTENANCE 1.25 1.25
MAINTENANCE
ENGINE
THROTTLE CABLE ADJUSTMENT
CS039
1
4
3
2
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.