Hotpoint ULTIMA FDW80 - Manual (Page 19)

19
Pre-Wash Programme Selected -There is no drying cycle on the Pre-Wash Programme.
Is Rinse Aid being used or is the
Rinse Aid level set too low? -Using rinse aid in your wash will improve the drying performance.
To add rinse aid to your wash follow instructions
below:
Step 1: Rotate cap anti-clockwise and pull to remove.
Step 2: Pour rinse aid into container and secure cap back into
position.
The level of rinse aid used during your wash cycle can be
adjusted to ensure best results.
Rinse Aid Levels 1 (lowest)
to 6 (Highest)
Rinse Aid level adjuster is
located under dispenser cap.
Using small coin rotate adjuster to
desired setting.
(We recommend setting to 4).
Rinse Aid Adjuster
Cap
Fault Area Issue Cause/How to resolve…
Poor Drying Results Quick Wash Programme
Selected
-There is no drying cycle on the Quick Wash Programme, unless
you have selected the “Extra Dry” option.
Follow instructions below on how to select “Extra
Dry”
Step 1: Press button marked “M” until the “Extra Dry” cycle
indicator is highlighted & “OFF” is illuminated in the
display.
Step 2: Activate the “Extra Dry” option by pressing the button marked
“S” until “ON” is illuminated in display.