Harbor Freight Tools 91062 - Manual (Page 8)

Page 8 For technical questions, please call 1-800-444-3353. SKU 91062
SPEciFicatiOnS
Electrical
Requirements
120V / 60 Hz / 6 A
16,000 Motor RPM
33,000 Cuts Per Minute
Max. Planing Width 3-1/4”
Max. Planing Depth 1/16” Per Pass (Adjustable)
Dust Chute Dim. 1-1/2” I.D. x 1-11/16” O.D.
Blade Dimensions 7/32” W x 3-3/16” L x 3/64” H
Number of Blades 2
Blade Composition 65 Manganese Alloy Steel
Shoe Plate Dim. 3-1/4” W x 6-1/2” L
Guide Dim. 3-1/4” W x 2-7/8” L
225428
unPacKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
inStructiOnS FOr Putting
intO uSE
read the EntirE iMPOrtant
SaFEtY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
tO PrEVEnt
SEriOuS injurY
FrOM accidEntal
OPEratiOn:
turn the Power Switch of the tool
off and unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Warning: chEcK BladE SEtting and
tightnESS BEFOrE initial uSE.
Functions
triggEr (16)
SaFEtY lOcK
ButtOn (17)
dEPth
KnOB
(48)
dial (51)
The Trigger (16) of the Planer features
a Safety Lock Button (17) to prevent
accidental starting of the tool. To start
the tool, depress the Safety Lock Button.
Squeeze the Trigger, and release
pressure on the Safety Lock Button. To
stop the tool, release pressure on the
Trigger.
OPErating inStructiOnS
read the EntirE iMPOrtant
SaFEtY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
tool Set up
tO PrEVEnt
SEriOuS injurY
FrOM accidEntal
OPEratiOn:
turn the Power Switch of the tool
off and unplug the tool from its
electrical outlet before adjusting
tool or installing accessories.
1. The Planer may be adjusted to cut to a
depth of up to 1/16” per pass along the
wood stock. To increase the depth of
cut, turn the Depth Knob (48) clockwise.
rEV 04b; 07c; 11a; 12d