Harbor Freight Tools 91062 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. SKU 91062
continue planing slowly to the end of the
cut. Do not pull the Planer back over the
surface already cut.
4. If necessary, repeat Step #5, using
progressively deeper cuts until you near
the desired depth. Then, readjust the
Depth Knob (48) to make a light cut for
the final pass.
nOtE: The Planer’s Motor may stall if the
tool is improperly used. If the Motor
begins to stall, reduce the feed speed
at which you are making the cut and/or
reduce the depth of the cut.
5. When finished planing, release pressure
on the Trigger (16) and the Planer will
automatically stop. Wait until Planer
blade comes to a complete stop.
6. To prevent accidents, turn off the tool
and disconnect its power supply after
use. Clean, then store the tool indoors
out of children’s reach.