Harbor Freight Tools Heavy Duty Air Paint Spray Gun 97855 - Manual (Page 7)

SKU 97855 For technical questions, please call 1-800-444-3353. Page 7
FUNCTIONAL DESCRIPTION
Specifications
Cup Capacity 1 Quart
Operating Air Pressure 60 PSI
Maximum Air Pressure 115 PSI
Air Consumption
10 SCFM @ 60 PSI
Air Inlet 1/4" -18 NPS
Nozzle Size 0.07"
Needle Size 1/8" dia.
Draw Type Siphon Feed
Spray Pattern
Horizontal, vertical,
round, diagonal
Components and Controls
Fig. 1
Fluid Control
Knob (16)
Trigger (7)
Cup
Locking
Lever (32)
Air Inlet (20)
Cup Mounting
Yoke (33)
Cup (31)
Pattern Control Knob (10)
Air Cap (1)
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.