HP 4800 Series - Manual (Page 11)

3. Remove the negative strip holder, if present, from the slide holder.
4. Place the slides into the slide holder. Insert the slides with the top of the slides
pointing up and with the front of the slides facing you.
5. Close the scanner lid.
Note Make sure that the slides are flat and do not overlap. Do not press
the Scan Film button until the slides are loaded and the lid is closed.
6.
Press the Scan Film ( ) button on the scanner, or click Scan Film in HP
Solution Center.
7. In the HP Scanning dialog box, select Picture.
8. Select Scan positives, including 35 mm slides, using the TMA.
If you want to preview the scanned picture, select the Show Preview check box
on the screen, or begin the scan from HP Solution Center.
9. Click Scan.
10. Follow the instructions on the screen to finish scanning.
The scan is sent to the destination selected in the HP Scanning dialog box.
11. When finished, remove the slides. Place the negative strip holder back into the
scanner lid for convenient storage, and then replace the TMA cover.
Scan negatives — HP Scanjet 4850
To scan 35 mm negatives, use the negative strip holder. The negative strip holder is
stored within the slide holder that is part of the built-in transparent materials adapter
(TMA).
Chapter 1
8 HP Scanjet 4800 series