beautypg.com

Home bar (only for hrf-689ff/a series), Operation of icemaker and cold water supplier – haier HRF-689FF/A User Manual

Page 17

background image

Home bar (only for HRF-689FF/A series)

15

A cantilever tabletop of the home

bar

Do not cut food on the tabletop to avoid

damages caused by sharp edges.

Do not apply excessive weight on the

tabletop.

Do not remove inner cover of the

home bar.

The home bar will cease operation if the inner

cover is removed.

Ensure that the home bar is out of

reach of children.

Accidental fault may cause damages to the

home bar or injuries to children.

Caution: For the sake of energy efficiency

and access convenience, the home bar

can be used without opening the door of

the refrigerator. Close the door of the

home bar immediately to avoid losses of

cold temperature in the refrigerator

compartment.

Operation of icemaker and cold water supplier

18

Before using the ice maker and cold water supplier

* Water supply tube installation

* Pressure of the cold water supplied to the automatic ice maker is between 0.15~0.85Mpa.

* The water tube should be cut with necessary length, free from bend. Suggested maximum

length of the water tube is approximately 12 meters. The water tube with excessive length may

affect the capacity of ice making due to the loss of water pressure.

* The water tube should be away from any heat resource.

* Since the purifier does not function for sterilization of any bacterium, it is strongly recommended

that drinking water be used for ice making.

* The water tubes should be installed and tested by professionals.

* When the appliance is put into operation for the first time, keep the Cold Water button pressed

every one minute to supply cold water into the tank into the refrigerator/freezer compartment

until cold water is supplied. Never press the cold water button for an extended period or the

water valve may become excessively warm.

Caution:

Before connecting the appliance with the water supply resource, ensure that the hand of the

ice maker is set to position "O".

This manual is related to the following products: