Harbor Freight Tools 67046 User Manual

Page 8

SKU 67046

For technical questions, please call 1-800-444-3353.

Page 8

tool set up

to preVent

serious injurY

From accidental

operation:

turn the power switch of the

tool to its “oFF” position and

disconnect the tool from its

battery pack before

performing any inspection,

maintenance, or cleaning

procedures.

Press a sand paper sheet onto the

Hook and Loop surface of the Mount-

ing Pad (10).

charge the Battery

The Charger (SKU 67031) and

Rechargeable Battery Pack (SKU

67029) are sold separately. Please

refer to the 67031 Charger manual

for important safety warnings and

proper instructions on charging tool.
Warning! Do NOT use a different

Charger or Battery Pack to power this

tool.

general operating instructions

Attach the fully charged Battery Pack

(sold separately) to the base of the

Sander.
To power the Sander for short bursts,

press in and hold the Power Switch

(13), then release it to stop.
To lock the Power Switch on for con-

tinuous use:

Hold down the Power Switch (13),

then depress the Lock Button.

Release the Power Switch, then

release the Lock Button.

Turn off by depressing then releasing

the Power Switch.
Sand the workpiece evenly with

gentle, broad, sweeping strokes in a

crisscross pattern.
To prevent accidents, turn off the tool

and disconnect its power supply after

use. Clean, then store the tool in-

doors out of children’s reach.