Humax ND-1000C - Manual (Page 13)

Safety
11
1. SMART CARD SLOT
Slot for a smart card.
The Smart Card is to be placed in the slot with the arrow “This way up” facing upwards
(i.e. Chip-side upwards).
NOTE: THE CARD IS TO BE INSERTED GENTLY TILL IT STOPS AND REMAINS
APPROX. 1 CM OUTSIDE.
2. CH-/+
Moves the TV/Radio channel up/down.
3. STANDBY Button
Switches between Operation and Standby modes.
While watching the analog Fee-To-Air Channels, the Set-Top Box should be in the
STANDBY mode.
NOTE: IF POWER TO THE STB IS SWITCHED OFF, YOU CANNOT VIEW THE
ANALOG FREE-TO-AIR CHANNELS.
1.2 Front Panel
1. CABLE IN
Connect the incoming Cable-TV signal to the CABLE IN jack on the Set-Top Box.
2. CABLE OUT
Connect the outgoing cable from CABLE OUT to the TV set.
3. AUDIO R/L
Connect the AUDIO R to the TV AUDIO IN and AUDIO L to the TV AUDIO IN using
RCA-RCA cord.
4. VIDEO
Connect the VIDEO to your VIDEO IN of TV / VCR using RCA-RCA cord.
1.3 Rear Panel