beautypg.com

English – haier HWF5300AW User Manual

Page 28

background image

26

English

Repairs to the washing machine must only be carried out by qualified personnel. Repairs

carried out by inexperienced persons may cause injury or serious malfunctioning.
Contact your local service center.

Warning code

Abnormal item

Solution

ErLC

door lock abnormal

Pushing the door to check whether it is properly

close; cut off the power and then turn on again.

If error still exist, please contact service personnel.

ErUL

door unlock abnormal

Cut off the power and then turn on again. If error still

exist, please contact service personnel.

bloc punp

drainage abnormal

Cut off the power.

Check if the drain hose is bent or clogged.

Check if the height of the drain hose end is more

than 96" above the floor.

Check if the drain filter is clogged.

If error still exist, please contact service personnel.

Err3

temperature sensor error

Please contact service personnel.

Err4

heating resistor failure

Please contact service personnel.

no taps

water inlet error

Check the two water inlet hose nuts to see if they are

properly fixed.
Check if the inlet hoses are bent or clogged.
Check that water pressure is less than 0.03MPa.
Check if the water tap is not turned on.
Check if the water supply is failed.
If the problem is solved, touch the Start/Pause pad to

continue the cycle; If error still exist, please contact

service personnel.

Err7

motor no rotation error

Please contact service personnel.

Err8

water over flow error

The washer will auto drain out of water, and then

auto clean up; If error still occur, please contact

service personnel.

Er10

water level sensor error

Please contact service personnel.

UNB

unbalance error

It is not recommended to wash single item.
1.Cut off the power.
2. Redistribute the washing clothes.
3. Restart the spin cycle by touching “RINSE&/SPIN”

pad twice.

EUAr

communication error

between user interface

board and power board

Please contact service personnel.

door

door not closed

Close door, then touch the “start” pad again.

PF

The Power is Low

Please Contact Service Personel