haier HWF5300AW - Manual (Page 26)

WARNING: Repairs to the washing machine must only be carried out by qualified
personnel. Repairs carried out by inexperienced persons may cause injury
or serious malfunctioning. To reduce the risk of electric shock, disconnect this
appliance from the power supply before attempting any user maintenance.
Turning off the "Power" pad does not disconnect this appliance from the power
supply
Contact your local service center.
24
English
Problem Possible Cause Solution
Noise in
Button / Coin Trap
* Foreign objects such as
coins or safety pins may
be in drum or trap.
Stop washer and check
drum and trap filter. If noise
continues after washer is
restarted, call for service.
Vibrating noise * Have all the transportation
bolts and packing been
removed?
* Wash load may be
unevenly distributed in the
drum.
* Are all the feet resting
firmly on the ground?
See Installation Instructions
for removing transportation
bolts.
Stop washer and rearrange
wash load.
Adjust the leveling leg.
Make sure all four legs are
in firm contact with the floor
or the pedastal.
Water leaks * Fill hose connection is
loose at tap or washer.
* House drain pipes are
clogged.
Check and tighten hose
connections.
Unclog drain pipe. Contact
plumber if necessary.
Excessive suds * Too much detergent or
unsuitable detergent.
Reduce detergent amount or
use low sudsing detergent.
Your washer is designed
specially to use only hE
"high Efficiency" detergent
Water does not enter
washer or it enters
slowly
* Water supply is not
adequate in area.
* Water supply tap is not
completely open.
* Water inlet hose is bent.
* The filter of the inlet hose
clogged.
* Water pressure is less than
0.03MPa
Check another tap in the
house.
Fully open tap.
Straighten hose.
Check the filter of the inlet
hose.
Check water pressure.
tRoUBLesHootING