Hotpoint BU62 BU65 - Manual (Page 29)

3. OVEN DOORS
(a) Control Panel
Regularly wipe with a clean, damp cloth and polish
with a clean, dry cloth.
(b) Trims
It is advisable to clean the trims regularly to prevent any build up
of soiling which may detract from the appearance of the cooker.
The recommended method of cleaning is to wipe over the trims
with a clean, soft cloth wrung out in warm water, or mild non
abrasive cleaner. (If in doubt try the cleaner on a small area of
trim which is not noticeable in normal use), then after wiping
with a cloth wrung out in clear water, dry with a clean, soft cloth.
(c) Inner Door Panels & Glass
Open the door fully. The glass panel may now be washed.
Stubborn stains can be removed by using a well soaped,
fine steel wool soap pad.
(d) Door trims (BU65 only)
Regularly wipe with a clean, damp cloth and polish with a
clean dry cloth.
4. REPLACEMENT OF THE OVEN LAMP
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove the lens.
Carefully unscrew the bulb anti-clockwise. Fit
replacement bulb (15W 300°C SES). Fit replacement
bulb and refit lens.
5. HOW TO CLEAN THE LAMP LENS
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove.
Clean with a non-abrasive cleansing cream and refit
lamp lens.
CARE AND CLEANING
29
DO NOT use scouring pads, or abrasive powder, which will
scratch the glass.
Warning: Before removing lamp lens, please ensure that the
electricity supply to the appliance is switched off and the
appliance is fully cold.
Warning: Before cleaning lamp lens, please ensure that the
electricity supply to the appliance is switched off and the
appliance is fully cold.
DO NOT use scouring pads, or abrasive powder, which will
scratch the glass lens
CONTROL PANEL
TRIMS
OVEN
DOORS
TOP OVEN LAMP
MAIN OVEN LAMP
TOP OVEN LAMP
MAIN OVEN LAMP
❍
❍
❍