Heath Zenith Lighted Wireless Push Button Accessory - Manual (Page 2)

-2- 598-1137-02
1. Install two lithium type CR2032 3 volt bat-
teries (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver. Make sure battery is oriented properly
(see page 5).
2. Set the push button jumpers to match the
chime receiver code. See “Code and Tune Setting” section.
3. Test range. Temporarily position push button where you want it
mounted. Press push button to verify chime and push button work
properly. If chime does not sound, see Troubleshooting.
4. Mount push button. Use either screws or double sided tape to mount
push button.
• To mount with screws, remove back of case by pushing in tab on
bottom with a small screwdriver. Attach back of case to door jamb
or wall. Snap front of push button on.
• When attaching push button using double sided tape, make sure
the surface of the door jamb or wall is clean.