Harbor Freight Tools 18 GAUGE BRAD NAILER 68021 - Manual (Page 14)

Page 14 For technical questions, please call 1‑800‑444‑3353. SKU 68021
2. If a fastener is jammed in the Magazines,
depress the Latch and pull back on the
Sliding Magazine, pulling it out of Fixed
Magazine.
3. Pull out the jammed fastener and the
remainder of the fastener strip that is
still in the magazine. Dispose of the
remaining fastener strip; it may be bent
or damaged in some other way.
4. If a fastener is jammed in the Drive
Guide, pull on the Quick Release Lever
(44) and disengage the Quick Release
Spring (45).
5. Remove the jammed fastener; pliers
maybe necessary to remove a stuck
fastener.
6. Inspect the Drive Guide for any bends or
breakage. If it is damaged, do not use
the tool until it is repaired by a qualified
technician.
7. Lightly oil the Drive Guide, engage the
Quick Release Spring, and snap the
Quick Release Lever back into place.
8. Make sure that the Safety Tip moves
smoothly without biding.
9. Reload the Nailer and then reconnect it
to the air supply.
10. Press the Safety of the Nailer against an
appropriate piece of scrap wood.
11. Test fire the Nailer several times,
checking for proper operation.
12. Disconnect the Nailer, remove the
fasteners, and store in a location out of
children’s reach.
13. If you are unable to clear the fastener
jam using the method prescribed above,
the tool should be taken to a qualified
service technician for proper servicing.