beautypg.com

The tank, Attach and remove brushes and pads – Hoover Shampoo- Polisher User Manual

Page 7

background image

The tank

The tank has one section for stor-
age of fresh cleaning solution and

one section for storage of dirty

solution that has been picked up
from the floor.

To fill tank

A. Remove tank by pressing tank

handle down and pulling tank for-

ward.

B. Lift cap marked “FILL”. Pour
premeasured cleaning solution

into opening marked “CLEAN
SOLUTION” until it reaches the

“FULL” line on the tank.

To empty tank

To empty dirty solution, remove
tank and pour from the opening

marked “USED SOLUTION”.
Rinse used solution container with
clear water. Clean solution may be
emptied by opening “FILL” cap
and pouring from the “CLEAN
SOLUTION” opening.

Attach and remove

brushes and pads

Disconnect from electric circuit
before putting on or removing
brushes.

Place shampoo-polisher upside

down on a flat surface. Press

each brush firmly down over
brush shaft, rotating brush until a
click indicates that it is in the cor-

rect position. To remove-grasp
center with thumb and fingers

and lift up brush.

6