Hoover Shampoo- Polisher - Manual (Page 13)

To achieve a high lustre finish
1. Attach felt buffing pads over scrubbing-waxing-polishing brushes using
fasteners. Polish to a soft shine by guiding shampoo polisher in straight lines
or with the grain of the wood. If more shine is desired proceed to step
2.
2. Remove felt buffing pads and attach high lustre polishing pads. Once
again, guide the handle in straight lines or with the grain of the wood to
achieve a high lustre finish.
To keep floors bright and shiny
Buff floor often to restore sheen and remove scratches and marks. This
lengthens the time between waxings. Before buffing, use a vacuum
cleaner to remove dust and dirt and a damp cloth to remove sticky
particles. Stubborn spots, such as black heel marks, can be removed by
rubbing gently with very fine steel wool dampened with wax.
If traffic areas need to be rewaxed and polished, and a solvent-base wax
has been used on the floor, apply wax only to these areas then buff the
entire floor.
Quick pickups
Liquids spilled on hard surface floors, such as water, or soft drinks, can
be picked up with your shampoo-polisher.
Before plugging unit into electrical outlet, attach scrubbing-waxing-pol-
ishing brushes. Put a small amount of water into the tank. Move control
button to the “WET PICKUP” position to remove liquid from floor. Rinse
floor by moving control button to the “SCRUB-POLISH-SHAMPOO”
position, and squeeze trigger to dispense clear water. Use “WET
PICKUP” to remove rinse water.
12