Harbor Freight Tools MOTORCYCLE LIFT 94813 - Manual (Page 8)

SKU 94813 For technical questions, please call 1-800-444-3353 PAGE 8
2.
STOP PLATE
(1)
BOLT
(2)
WASHER
(29) NUT
(27)
FIGURE D
Align the two mounting slots in the Stop Plate (1) with the two mounting holes located
at the rear of the Platform (8). Then secure the Stop Plate to the Platform, using two
Bolts (2), two Washers (29), and two Nuts (27). NOTE: When adjusting the Stop
Plate forward or backward, make sure to retighten the two Nuts. (See Figure D.)
To Install The Vise Assembly:
1.
NUT
(27)
WASHER
(29)
FIGURE E
VISE ASSEMBLY
(4, 6, 7)
NOTE: Additional mounting holes at the rear of the Platform (8) allow for adjusting
the forward/backward location of the Vise assembly. (See Figure E.)
2. To install the Vise Assembly (4, 6, 7), align the ten mounting holes at the base of
the Vise Assembly with ten of the mounting holes located at the rear of the Platform
(8). Then secure the Vise assembly to the Platform, using ten Bolts (2), Washers
(29), and Nuts (27). (See Figure E.)
Rev 11a