Harbor Freight Tools MOTORCYCLE LIFT 94813 - Manual (Page 5)

SKU 94813 For technical questions, please call 1-800-444-3353 PAGE 5
14. Use compressed air only. Use clean, dry, regulated, compressed air. Never use
oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power
source for this tool.
15. WARNING! The warnings and cautions discussed in this manual cannot cover all
possible conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS
PRE-ASSEMBLY INSTRUCTIONS
NOTE:
For further references to the parts mentioned in the following pages,
see the Assembly Diagrams on pages 13 and 14 of this manual.
To Move The Motorcycle Lift To A Proper Location:
1.
A minimum of two adults are normally required to set up and operate the Motorcycle Lift.
2. Prepare for assembly by having a clean, spacious, well lit location. It is recom-
mended to assemble the Motorcycle Lift on the floor.
3.
DOLLY HANDLE
(1D)
HOOK
FIGURE A
AIR HOSE CONNECTOR (49)
FOOT AIR VALVE
(48)
PLATFORM
(8)
Once the Motorcycle Lift is unpacked, use the accessory Lift Dolly (58) to move
the Lift to the desired assembly location. To do so, insert the Hook on the Lift’s
bottom chassis into the hole at the bottom of the Lift Dolly. Press down on the
Dolly Handle (1D) to slightly raise the end of the Motorcycle Lift. Then, move the
Lift to the desired assembly location. (See Figure A.)
LIFT DOLLY
(58)