Warning – Hitachi 308640 User Manual
Page 3
308640 3
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result
in serious injury.
D
This equipment is for professional use only.
D
Read all instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check the equipment daily. Repair or replace worn or damaged parts immediately.
D
Do not exceed the maximum working pressure of the lowest rated system component. This equip-
ment has a 4000 psi (28 MPa, 280 bar) maximum working pressure at 100 psi (0.7 MPa, 7 bar)
maximum incoming air pressure.
D
Route the hoses away from the traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180
_
F (82
_
C) or below –40
_
F (–40
_
C).
D
Do not use the hoses to pull the equipment.
D
Use only Graco approved hoses. Do not remove hose spring guards, which help protect the hose
from rupture caused by kinks or bends near the couplings.
D
Use fluids or solvents that are compatible with the equipment wetted parts. See the Technical
Data section of all the equipment manuals. Read the fluid and solvent manufacturer’s warnings.
D
Wear hearing protection when operating this equipment.
D
Comply with all applicable local, state and national fire, electrical and other safety regulations.
FIRE AND EXPLOSION HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
D
Ground the equipment and the object being sprayed. See Ground the System on page 6.
D
Provide fresh air ventilation to avoid the buildup of flammable fumes from solvent or the fluid being
sprayed.
D
Extinguish all the open flames or pilot lights in the spray area.
D
Electrically disconnect all the equipment in the spray area.
D
Keep the spray area free of debris, including solvent, rags, and gasoline.
D
Do not turn on or off any light switch in the spray area while operating or if fumes are present.
D
Do not smoke in the spray area.
D
Do not operate a gasoline engine in the spray area.
D
If there is any static sparking while using the equipment, stop spraying immediately. Identify and
correct the problem.