haier TFT-LCD - Manual (Page 34)

In VGA and DVI input mode, H-Position and V-Position can be adjusted to eliminate
transverse line interference.
PC setting
1
2
Press
Press CH+/- buttons to
select RGB, then press VOL-
/+ buttons to enter the sub
menu.
CH+/- buttons to
select the desired item, press
VOL+/- button to adjust.
Multiple picture position setting
31
NOTE As the frequency of
display differ in PC device
you may select the appropriate
frequency to obtain desired effect.
If the signal of receive is excess,
the picture can be not displayed
or wrong on the screen.
This is opted for adjustment of picture location requency and
phase parameters in VGA mode.(After the operation, complete
will be on the right of the operation)
In VGA , if no signal input, the Auto Sync will be no adjustable.
Sequence frequency
H-frequency
KHz
Remark
31.5
37.88
48.36
60
60
60
DOS
VESA
VESA
Note
V-frequency
Hz
Recommendatory frequency as follow:
(Continue)
Display Mode Normal
Color Temperature Normal
Black Stretch On
Adjust
RGB
Default
Auto Sync .
B
C
A
Red
Green
Blue
B
C
A
0
0
0
RGB is opted for adjustment
of the numerical value of red,
green and blue in VGA/DVI
mode.
Default
Auto Sync
Repeat step 1 and 2 to set the Default.
This is opted for adjustment of parameters to delivery setup
in VGA mode.(After the operation, complete will be on the
right of the operation)
Repeat step 1 and 2 to set the . Auto Sync
Adjust menu