Hitachi VT-FX602S - Manual (Page 45)

SEARCH - 45 -
position to forward direction.
1 Select "TIME SEARCH" mode
Press TIME SEARCH button.
2 Enter your desired time
Press CH/SET
or button repeatedly until your desired time appears.
(Example: "2:50" for 2 hours 50 minutes)
TIME SEARCH
2 : 50
3 Begin Time Search
Press REW or F.FWD button. The VCR begins rewinding or fast
forwarding to the specified point.
The time counts down as the searching progresses.
4 After Time Search
When 0:00 is reached, the VCR will start playback automatically.
NOTES:
• Time Search can be set up to 9 hours 59 minutes (9:59).
• This function will not operate in recording mode.
• Procedures must be followed within 30 seconds, from steps [1] to [2]. Otherwise
the Time Search mode will be cancelled.
• Press STOP button to exit the Time Search mode.
INDEX SEARCH
This feature provides a method of indexing the starting point so that it can
be easily returned to in either fast forward or rewind mode.
• The index mark will be made automatically when the REC button is
pressed. It will also be marked at the starting point of Timer recording and
IRT.
• The index mark is not recorded if the PAUSE button is pressed and
released during recording.
• The time gap between making the index marks on the tape should be
greater than 1 minute for SP recording, 2 minutes for LP recording and 3
minutes for SLP recording.