Harbor Freight Tools SUBMERSIBLE DIRTY WATER PUMP 93820 User Manual
Page 8
SKU
93819
For technical questions, please call 1-800-444-3353
PAGE 8
93820
FIGURE D
SYMBOLOGY
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts List on page 12
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE:
For additional information regarding the parts listed in the
following pages, refer to the
Assembly Diagram on page 13.
1.
WARNING! Always make sure to turn off the electricity powering the
Pump’s electrical outlet and that the Pump is unplugged from its outlet prior to
assembling the unit, unclogging the unit, or making any adjustments to the unit.
2.
If necessary, have a certified electrician install (within 14 feet of where the Pump
will be located) a 120 volt, GFCI electrical outlet that is dedicated only to the
Pump.
Any outlet should be well above the water line.
3.
The size of the discharge outlet on the Union (37) is 1-1/2” diameter. Only a
1-1/2” diameter Discharge Pipe (not included) must be used. Do not attempt to
reduce the discharge size below 1-1/2” as this will affect Pump flow and perfor-
mance.
(See Figure E, next page.)