Harbor Freight Tools SUBMERSIBLE DIRTY WATER PUMP 93820 User Manual
Page 6
SKU
93819
For technical questions, please call 1-800-444-3353
PAGE 6
93820
GROUNDING
WARNING!
Improperly connecting the grounding wire can result in the risk of electric shock. Check with
a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do
not modify the power cord plug provided with the tool. Never remove the grounding prong
from the plug. Do not use the tool if the power cord or plug is damaged. If damaged, have
it repaired by a service facility before use. If the plug will not fit the outlet, have a proper
outlet installed by a qualified electrician.
10.
If necessary, have a certified electrician install (within 14 feet of where the
Pump will be located) a 120 volt, GFCI electrical outlet that is dedicated
only to the Pump. Any outlet should be above the water line.
11.
NEVER raise or lower the Pump by its electrical Power Cord.
12.
In cold weather, when the Pump is not in use, protect the interior of the
Pump from freezing by draining the water and pumping a permanent type
automobile anti-freeze containing a rust inhibitor through the system. A
50% mixture with water is recommended. Be sure to flush the system with a
neutralizing liquid prior to re-use of the Pump.
13.
Prior to use, and periodically thereafter, check to make sure all connections
are tight and secure.
14.
Industrial applications must follow OSHA requirements.
15.
Performance of this product may vary depending on variations in local line
voltage.
16.
WARNING! People with pacemakers should consult their physician(s) be-
fore using this product. Operation of electrical equipment in close proximity to a
heart pacemaker could cause interference or failure of the pacemaker.
17.
WARNING! The warnings and cautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS