Hunter Fan Grandview 23923 - Manual (Page 11)

11
42773-01 • 06/18/09 • Hunter Fan Company
ATTACHING THE UPPER SWITCH HOUSING
7-5. Locate the upper switch housing mounting screws in the sack parts.
7-6. Insert and tighten the screws into the outermost holes in the upper switch
housing.
CAUTION: Make sure the upper switch housing is securely attached
to the switch housing mounting plate. Failure to properly attach and
tighten all four housing assembly screws could result in water entry
into live connection area and/or the switch housing and light fixture
falling.
ATTACHING THE LOWER SWITCH HOUSING/LIGHT
ASSEMBLY
7-7. Locate the lower switch housing screws.
NOTE: Depending upon your fan model, these screws will be either
installed in the four spokes from the switch housing mounting plate, or
located in the sack parts.
7-8. Partially install the screws into the spokes from the switch housing
mounting plate.
NOTE: if these screws came installed, make sure that they are partially
installed in order to complete the following steps.
7-9. Connect the upper plug connector to the lower plug connector from the
lower switch housing assembly.
NOTE: Both plug connectors are polarized and will only fit together
one way. Make sure that both connectors are properly aligned before
connecting them together. Incorrect connection could cause improper
operation and damage to the product.
7-10. Align the keyhole slots in the lower switch housing with the housing
assembly screws that were installed in step 7-8.
7-11. Turn the lower switch housing clockwise until the housing assembly screws
are firmly situated in the narrow end of the keyhole slots.
7-12. Tighten all housing screws.
7 • Completing Your Installation With a Bowl Light Fixture (Continued)
Step 7-5
Step 7-7
Switch
Housing
Mounting
Screws
Housing
Screws
Spokes