Hunter Fan Grandview 23923 - Manual (Page 10)

10
42773-01 • 04/08/08 • Hunter Fan Company
Your Hunter fan comes with an integrated light fixture assembly.
WARNING: Use only the light fixture supplied with this fan model.
The switch housing assembly is made up of three sections: the switch housing gas-
ket, the upper switch housing, and the lower switch housing/light assembly.
ATTACHING THE SWITCH HOUSING GASKET
AND UPPER SWITCH HOUSING
7-1. Locate the switch housing mounting plate, the switch housing gasket and
the upper plug connector as shown.
NOTE: Your fan may come with the switch housing gasket attached to the
switch housing mounting plate.
If the switch housing gasket is attached to the switch housing mounting
plate, go to the section "Attaching the Upper Switch Housing."
If the switch housing gasket is not attached complete the steps below.
7-2. Identify the top side of the switch housing gasket by looking for the raised
circular ridge on the gasket.
7-3. With the top side of the switch housing gasket facing up towards the mo-
tor, align the holes in the gasket with the spokes on the switch housing
mounting plate.
7-4. Feed the upper plug connector through the center opening of the up-
per switch housing. Push the gasket up so that it is seated flush with the
mounting plate .
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light fixture falling.
Step 7-1
Step 7-3
Step 7-4
Gasket
Holes
Mounting
Plate
Spokes
Upper
Plug
Upper
Plug
Upper
Switch
Housing
7 • Completing Your Installation With a Bowl Light Fixture