Hitachi DV-S522U - Manual (Page 38)

-E37-
PAUSE/ST
EP
PRE
V NE XT -TU NE TUN E+
REV
SLOW
FWD
SLOW
CLEAR
TRIM
RETURN DISPLAY PROG
TV CH TV VOL
TV VOL TV CH TV/VIDEO
LAST MEMO REPEAT
SEARCH MODE
TV POWER
ENTER
SHIFT
S E T UP
T O P
M
EN
U SU BT
IT LE
M EN
U
0
8 7 9
+10
5 4 6
2 1 3
ANGLE A.REPLAY ZOOM
AUDIO SLEEP
TIMER ADJUST SET/CLEAR
CLOCK
SHIFT
SET/CLEAR TIMER
z / I
PAUSE/ST
EP
PRE
V NE XT -TU
NE TUN
E+
REV
SLOW
FWD
SLOW
CLEAR
TRIM
ENTER
SHIFT
S E T UP
T O
P
M EN
U SU
BT
IT LE
M EN
U
0
8 7 9
+10
5 4 6
2 1 3
ANGLE A.REPLAY ZOOM
AUDIO SLEEP
TIMER ADJUST SET/CLEAR
CLOCK
SHIFT
SLEEP
MAINTENANCE
WARNING:
FOR YOUR PERSONAL SAFETY, BE SURE TO
DISCONNECT THE AC POWER CORD BEFORE
PROCEEDING WITH ANY MAINTENANCE OR CLEANING.
Cleaning the cabinet
Use a clean soft cloth moistened with plain lukewarm water and
wrung dry. Never use benzol, benzene or other strong chemical
cleaners since these could damage the finish of your unit. It is
important that no liquid reaches the inside of the unit.
To release the timer
1. After turning the power on, press [TIMER] while holding
[SHIFT] down.
2. Press [SET/CLEAR] while holding [SHIFT] down.
Note:
•
If [SET/CLEAR] is pressed while holding [SHIFT] down, while
the timer is being set, the original display returns.
• The timer mode is released if a power failure occurs during
timer controlled operation.
• The timer may not operate if a power failure occurs during
timer operation standby mode.
Using the Sleep Timer
The sleep timer automatically switches off the power after a
preset time has elapsed. The volume will gradually be reduced
(fade-out) during the 1 minute period before the unit turns off.
There are 9 time periods available: 90, 80, 70, 60, 50, 40, 30, 20,
and 10 minutes.
Press [SLEEP] repeatedly while holding [SHIFT] down to select
the desired sleep time. “SLEEP” appears on the display.
After several seconds, the original display returns and the
brightness of the display reduces.
To check the remaining sleep time
Press [SLEEP] once while holding [SHIFT] down.
After several seconds, the original display returns.
To release the sleep timer while in operation
Press [SLEEP] repeatedly while holding [SHIFT] down until
“SLEEP” disappears.
The timer is also released if the power is switched off.