Fitting the hand guard and loop handle, Fitting the handle, Fitting the cutting head – Husqvarna 327HDA65X User Manual
Page 10: Assembly
ASSEMBLY
10 – English
Fitting the hand guard and loop
handle
(327HDA65, 327HE3)
1
Assemble the hand guard and loop handle by
screwing them together. Take care to align the holes
in both parts. (327HDA65)
2
Slide the loop handle and hand guard onto the shaft.
(327HDA65)
3
Slide the spacer into the slot in the loop handle.
4
Fit the nut and screw. Do not overtighten.
5
Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
CAUTION! The loop handle and hand guard must not
be fitted behind the arrow marked on the shaft.
Fitting the handle
(327HE3, 327HE4)
Fit the handle using two screws.
Fitting the cutting head
(327HDA65)
It is important that the hedge trimmer is laid on a flat
surface when you fit the cutting head. Otherwise the
cutting head may not be fitted straight.
1
Fit the cutting head to the shaft. CAUTION! Make sure
the drive shaft inside the shaft engages with the
recess in the cutting head.
2
Tighten the lower screw first, then the upper screw.