Huffy 211387 - Manual (Page 4)

4
P/N 211387 5/99
printed on recycled paper
5
WOOD SCRAP
4
6
Add bottom pole section (4) to assembly as
shown and bounce until completely tight. 5.
*
IMPORTANT!
Holes in top and bottom pole
sections MUST align to correctly
position elevator system.
Continue to check alignment
while assembling pole sections.
* Row of 3 holes on top pole
section must be parallel with
adjustment knob.
Once assembled, pole
sections can NOT be
separated!
POLES MUST OVERLAP
3-1/2” (9 CM) MINIMUM.
NOTE: Discard this carriage
bolt immediately after completing
this step. DO NOT discard flange
nut and washer.
6