Hoover Self-Propelled WindTunnel Cleaner - Manual (Page 7)

7
2-11
How to attach tool
cover
The tool cover is designed with a
“break-away” feature which allows it to
snap free if it is pushed open too far.
To reattach, align hinges of cover with
slots on sides of tool storage area.
Push cover down to secure in place.
How to clean tools
To clean the hose, wipe off dirt with a
cloth dampened in a mild detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air
dry before using.
Cleaning tools
When using cleaning tools, cleaner
handle should be in the upright posi-
tion to activate the automatic “brush
roll OFF” and for convenience in
moving the cleaner from one area to
another.
Turn cleaner OFF before disconnect-
ing and connecting hose to hose tube
(A).
To use hose, lift hose end as shown.
Attach wand and
tools
Attach tool or wand to the hose (B) by
pushing it firmly into hose.
Attach second wand or tool to wand (C)
by pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or
loosen the connection.
Stair Cleaning
You may use the hose and furniture noz-
zle for stair cleaning.
CAUTION: To prevent the cleaner
from falling, always place it at the bot-
tom of the stairs.
With handle in upright position, clean
from bottom to top.
Select proper tool
D. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
E. Furniture nozzle may be used for
upholstered furniture, draperies, mat-
tresses, clothing, automobile interiors,
and carpeted stairs.
F. Crevice tool may be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
G. Wands are used to give extra length
to your hose. Use them with any of the
above tools.
2-12
A
Continued ➜
2-14
F
G
E
D
2-13
B
C
2-15
H
Check bag indicator
The indicator (H) will begin to show red as
the filter bag fills with dirt.
There are three conditions that will cause
the indicator to become completely red:
1. If the bag is full; change the bag.
2. If very fine materials have been picked
up, clogging the bag pores; change the
bag.
3. If there is a blockage at the front of the
cleaner, in the hose, tools or at the bag
opening; remove the blockage (see
“Clearing blockages”section).