beautypg.com

On off, Edge cleaning, Cleaning lightweight flexible rugs – Hoover Self-Propelled WindTunnel Cleaner User Manual

Page 6: Carpet height adjustment, Handle positions, Carrying cleaner, Brush roll control

background image

Edge cleaning

Special edge groomers are provided on
both sides of the front of the cleaner to
remove dirt in carpet near baseboards
and furniture.

Guide either side parallel to the edge of
carpet or furniture.

BRUSH ROLL

CARPET

HARD

ON OFF

2-8

2-9

2-10

Cleaning lightweight
flexible rugs

Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the front of clean-
er as shown and will prevent rug from
clinging to cleaner.

Continue to lift front of cleaner so that
when you have reached the edge, it is
completely off the rug. Move cleaner
back to start again, lower front of clean-
er, and use only forward strokes.

CARPET HEIGHT

BRUSH ROLL

AUTOMATIC

BRUSH ROLL

ON OFF

ON OFF

Carpet height
adjustment

When it is necessary to raise and lower
the front of the cleaner for various car-
pet pile heights, slide the carpet height
control (A) to the desired setting. For
ease in sliding knob, place handle in the
upright position and tilt cleaner forward.

For maximum cleaning performance,

the following carpet height settings are
recommended:

• Low setting: for all types of carpet

• Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good clean-
ing performance.

Note: If the cleaner is difficult to push,
slide control to the next higher setting.

Handle positions

The handle of your cleaner has three
positions;

upright

for storage and when

using cleaning tools;

operating posi-

tion

for general operation on carpet

and floors;

low

for reaching under low

furniture.

Step on handle release lever to lower
handle.

Carrying cleaner

The cleaner can be moved by using
the carrying handle located on the back
of the cleaner.

6

2-5

2-6

Brush roll control

Note: When handle is in upright posi-
tion, brush roll is automatically OFF.

Move the brush roll control only when
the handle is in the upright position.

For ease in sliding knob, place handle
in the upright positon and tilt cleaner
forward.

Slide control to “Carpet” to turn brush
roll ON for cleaning carpet or rugs.

Slide control to “Hard” to turn brush roll
OFF when cleaning bare floors.

A

2-7