Harbor Freight Tools 7528 - Manual (Page 2)

SKU 07528 Page 2
REV 07g
Specifications
Chuck ½ inch, Jacobs type
Rated Air Pressure 90 PSI at 4 CFM
Recommended Hose 3/8 inch
Speed 800 RPM
Air Inlet ¼” – 18 NPT
Weight 3.75 lbs.
Save this Manual
You will need the manual for the safety warnings and precautions, assembly in-
structions, operating and maintenance procedures, parts list and diagram. Keep
your invoice with this manual. Write the invoice number on the inside of the front
cover. Keep the manual and invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be fol-
lowed to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. Disconnect air before servicing. Do not attempt to disassemble or service
tool with air hose attached.
2. Use only specified operating air pressure. Recommended tool operating
air pressure is 90 PSI.
3. Do not use combustible gases. Do not use combustible gases as a power
source, or use tool in areas where combustible gases are stored.
4. Avoid possible kickback injury. Hold the tool with both hands during
operation so that your head and body are not injured by possible kickback of
the tool.
5. Use care when transporting tool. Disconnect tool from air supply when
moving tool in the workplace. Carry tool only by the handle without drawing
the trigger.
6. Keep work area clean. Cluttered areas invite injuries.
7. Observe work area conditions. Do not use machines or power tools in
damp or wet locations. Don’t expose to rain. Keep work area well lighted.
8. Keep children away. Children must never be allowed in the work area. Do
not let them handle machines, tools, or extension cords.
9. Store idle equipment. When not in use, tools must be stored in a dry
location to inhibit rust. Always lock up tools and keep out of reach of
children.