beautypg.com

Specifications, Unpacking, Assembly – Harbor Freight Tools 99741 User Manual

Page 9

background image

For technical questions, please call 1-800-444-3353;

troubleshooting section at end of manual.

SKU 99741

PAGE 9

SPecIFIcatIOnS

Electrical Requirements 120 V / 60 Hz / 13 A

35 Ft. Long Power Cord

Water Pressure

1,600 PSI

Flow Rate

1.6 GPM

Water Supply Required

3-4 gPm minimum

Hose Length

19 Ft.

unPackIng

When unpacking, check to make sure

that the item is intact and undamaged. If

any parts are missing or broken, please

call Harbor Freight Tools at the number

shown on the cover of this manual as soon

as possible.

aSSemblY

read the entIre ImPOrtant

SaFetY InFOrmatIOn

section at the beginning of this

manual including all text under

subheadings therein before set

up or use of this product.

tO PreVent

SerIOuS InjurY

FrOm accIdental

OPeratIOn:

before performing any

inspection, maintenance, or

cleaning procedures:

turn the Power Switch of

a.

the equipment to its “OFF”

position.

unplug the equipment from its

b.

electrical outlet.

Shut off water supply.

c.

Safely discharge all residual

d.

water pressure.

disconnect water supply

e.

hose.

note: For additional information regarding

the parts listed in the following pages,

refer to the Assembly Diagram near

the end of this manual.
Check the Inlet Strainer for any block-

1.

age, including packaging debris. The

Pressure Washer may be shipped

with a plastic plug in the Inlet.
Position the rear of the Handle above

2.

the rear of the Pressure Washer

body. Connect the Suction Tube from

the top of the Pressure Washer body

to the connector on the bottom of the

Detergent Bottle in the Handle. Make

sure that the Suction tube does not

bend or get pinched during assembly.

Lower the Handle onto the Pres-

sure Washer Body. Then secure the

Handle to the Pressure Washer body,

using the Screws provided.
Insert the Spray Wand into the Wa-

3.

ter Gun, and twist the Wand into the

Extension until the Wand locks in

place. Pull the Wand to make certain

it is secure.
Attach the High Pressure Hose to the

4.

Outlet Port on the front of the Pres-

sure Washer.
Attach the female part of the Quick

5.

Connector Set to the Supply Port on

the back of the Pressure Washer. At-

tach the male part of the Quick Con-

nector Set to a heavy-duty garden

hose (not included). Then, pull back

on the collar on the Female quick

connector and insert the male Quick

Connector.