Harbor Freight Tools 99741 - Manual (Page 20)

For technical questions, please call 1-800-444-3353. SKU 99741 PAGE 20
If the steps above do not solve the problem or if the repairs involved are
too complex, contact a qualified technician.
Shut off the Pressure Washer, release all pressure in a safe
manner, and disconnect it from power and water before adjusting,
cleaning, or repairing the unit.
trOubleShOOtIng
the following points should
be applied to help reduce the
frequency of rest periods:
eliminate any extension cord used. 1.
use proper operating techniques. 2.
review the Operating tips section,
starting on page 14.
Verify that this unit is being supplied
3.
with the correct voltage, see page 11,
#2. connect the plug to the outlet
nearest the circuit breaker panel and
remove any other loads that may be
on the circuit.
Pressure Washer Stops Suddenly
dry self thoroughly
and check the
circuit breaker on
your household
panel.
make sure unit is
totally dry, then
press reset button.
If gFcI continues
to trip, contact
a certified
electrician.
check for electrical shorts.
If none are found, reset
breaker.
If breaker continues to
trip, try another circuit
or contact a certified
electrician.
breaker
nOt trIPPed
breaker trIPPed
the thermal safety Switch may be
tripped. Switch the unit off. allow the
unit to rest for 20-30 minutes and retry.
unIt OPerateS
nOrmallY aFter
reStIng
unIt dOeS nOt
reStart
check the indicator on the gFcI
power plug (explained under Controls
and Features, #1 on page 10).
contact
qualified
technician.
Water leaking from within the housing
Seals may be worn or damaged.
leaking water creates a shock hazard.
ImmedIatelY discontinue use. have the unit repaired
by a qualified technician before further use.
IndIcatOr dOeS
nOt aPPear
IndIcatOr
aPPearS