HONDA EU 1000i - Manual (Page 20)

18
SPECIAL REQUIREMENTS
Do not lay the generator on its side when moving, storing, or
operating it. Oil may leak and damage the engine or your property.
There may be Federal or State Occupational Safety and Health
Administration (OSHA) regulations, local codes, or ordinances that
apply to the intended use of the generator. Please consult a qualified
electrician, electrical inspector, or the local agency having jurisdiction.
In some areas, generators are required to be registered with local
utility companies.
If the generator is used at a construction site, there may be
additional regulations that must be observed.
Keep all cooling holes open and clear of debris, mud, water, etc.
Cooling holes are located on the side panel, the control panel, and the
bottom of the generator. If the cooling holes are blocked, the
generator may overheat and damage the engine, inverter, or windings.
06/12/21 11:34:57 31ZT3604_019