Husqvarna 362XP - Manual (Page 2)

2 – English
KEY TO SYMBOLS
Symbols on the machine:
WARNING! Chain saws can be dangerous!
Careless or improper use can result in
serious or fatal injury to the operator or
others.
Please read the operator’s manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ′ s hands must be used to
operate the chain saw.
Never operate a chain saw holding it with one
hand only.
Contact of the guide bar tip with any object
should be avoided.
Tip contact may cause the guide bar to move
suddenly upward and backward (so-called
kickback), which may cause serious injury.
Other symbols/decals on the machine
refer to special certification requirements
for certain markets.
Symbols in the operator’s manual:
Switch off the engine by moving the stop
switch to the STOP position before carrying
out any checks or maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil flow.
The chain brake must be engaged when the
chain saw is started.
Never let the guide bar tip come in contact
with any object.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
You will find the following labels on your chain saw:
EPA I
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of operating
hours for which the engine has been shown to meet Federal
emissions requirements. Category C = 50 hours, B = 125
hours, and A = 300 hours.