Harbor Freight Tools 67450 - Manual (Page 14)

Page 14 For technical questions, please call 1-800-444-3353. Item 67450
Loading the Tool
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING:
• Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• Release the trigger.
• Detach the air supply.
• Attempt to fire the Tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
1. Push down on the Latch (68) and swing the
Catch (64) and the Canister Cover (89) open.
Latch (68)
Catch
(64)
Canister
Cover
(89)
Canister (82)
2. Check the Adjuster Plate (86) inside the
Canister (82). Rotate the Adjuster Nut (88)
to adjust the Platform to match the nail length:
A. Between 3/4″ and 1″ Long Nails
(Use top setting).
B. Between 1″ and 1-1/4″ Long Nails
(Use middle setting).
C. Between 1-1/4″ and 1-3/4″ Long Nails
(Use bottom setting).
3. Turn the Adjuster Nut (88) clockwise to
raise the Adjuster Plate (86) until its edge
aligns with the embossed nail size markings
on the inside wall of the Canister.
4. Place a coil of Nails around the Adjuster
Plate (86) in the Nail Canister (82).
Canister
Cover
(89)
Adjuster
Plate (86)
Canister (82)
Feed
Hook
(50)
Nails
5. Swing the Canister Cover (89) closed.
6. Close the Catch (64). Make sure the Latch closes
securely. If it does not engage, the nail head is
not in the slot in the upper portion of the Feed
Hook (50) and nail shank is not in the feeder.
SAFETY
OPERA
TION
MAINTENANCE
SETUP