Hoover Commercial Lightweight Cleaner with Dirt Cup - Manual (Page 2)

2
Note: The white switch lock above the ON/OFF (A)
switch helps in the assembly of your cleaner.
Assembly can be continued if the switch lock is miss-
ing. However,
do not remove the switch lock until
assembly is completed.
UP
Align upper handle and lower
handle as shown.
Place upper (B) and lower (C) handle parts on a flat surface,
aligning rod sections (D). With hands on sides of handle,
push parts together firmly until they “click” and rod sections
lock together.
Step 2 Attach cord
Insert large rectangular end of cord into pocket in bot-
tom of handle, with side marked “UP” visible.
Make sure rectangular end is pushed into the handle
as far as possible.
Slide cord protector (F) toward upper handle (G).
1-2
1-3
B
C
F
E
G
E
1. Assembling cleaner
It is extremely important to read and
follow all the assembly steps in order.
Carton contents
Remove all parts from carton and
identify each item shown. Make
sure all parts, especially small
items, such as G and F, are locat-
ed before disposing of cardboard
packaging. A. Upper handle
B. Lower handle
C. Cord
D. Dirt cup assembly
E. Cleaner body
1-1
A B
C
E
F G
H
D
Step 1 Assemble handle
*Do not press against the grey rod extend-
ing from the lower handle shown in Fig. 1-3
(E). Do not push handle together with
hands on ends of sections.
F. Handle bolt and nut
packet (One extra nut
included)
G. Dirt cup screws (2)
H. Dirt cup support
UP
A
D