Henny Penny 520 User Manual
Page 6
Henny Penny
Model 520
7-6. SPECIAL PROGRAM
MODE
Function
Four Product Control
Ten Product Control
Enter Special Program
1. Turn key switch to “Program”
1. Turn key switch to “Program”
2. Press and hold the “Program”
2. Press and hold the “Program”
button for 10 seconds.
button for 10 seconds.
3. Display shows revision level
3. Display shows revision level
and then “SPCL Prog”.
and then “SPCL Prog”.
o
F or
o
C
4. Left display shows “deg”,
4. Left display shows “deg”,
right display shows
o
F or
o
C
right display shows
o
F or
o
C
5. Push change buttons (L or R)
5. Push change buttons (J)
to select
o
F or
o
C.
to select
o
F or
o
C.
Probe calibration
6. Push PROGRAM button (G)
6. Push PROGRAM button (G)
7. Left display shows “Prob”
7. Left display shows “Prob”
then “Calib”.
then “Calib”.
8. Adjust calibration settings
8. Adjust calibration settings
with change buttons (L or R)
with change buttons (J).
Initialize Controls
9. Push PROGRAM button (G)
9. Push PROGRAM button (G)
10. Left display shows “init”,
10. Left display shows “init”,
right display shows “SYS”.
right display shows “SYS”.
11. Push and hold change buttons
11. Push and hold change buttons
(L or R) for 5 seconds.
(J) for 5 seconds.
12. Special Program is automatically 12. Special Program is automati-
exited.
cally exited.
NOTE
NOTE
This programs factory settings
This clears all settings to 0 or
to controls.
minimum value.
Inputs/Outputs
13. Push PROGRAM button (G)
13. Push PROGRAM button (G)
to skip Initialize Controls.
to skip Initialize Controls.
14. Left display shows “I O”,
14. Left display shows “I O”,
right display shows “test”.
right display shows “test”.
15. Push each button to test
15. Push each button to test
displays and LEDs, and
displays and LEDs, and
INTERVAL SELECT (S) button
Temp button (K) to turn on
to turn on heat and pressure.
heat and pressure.
Exit Program Mode
16. Turn key to “COOK” position.
16. Turn key to “COOK” position.
7-6
600