Hoover Vacuum Cleaner - Manual (Page 13)

4.28 With lettering on outside of belt, slide new belt
over motor shaft (metal rod) (E).
Push other end of belt through belt guide (F) and
over metal pulley*, then slip around area of brushroll
without bristles (G).
With belt in place, pull and slide brushroll into nozzle
making sure that the brushroll end caps are in the
correct orientation.
4.29 Reposition bottom plate, aligning the three
tabs along front edge of nozzle guard with the three
slots in nozzle. Rotate back into position. Slide red
lower latch to Lock position, and rotate red upper
latch clockwise to secure bottom plate.
*Models without “Suction Only Mode” do not have
the metal pulley
4.28
E
G
what to buy: belt
Use only genuine HOOVER ® belts with your
vacuum.
When purchasing a new belt for models with
Brushroll On/Off (Suction Only Mode), ask for
Flat Belt - HOOVER
® part No. 562289001 or
AH20065.
When purchasing a new belt for models without
Brushroll On/Off (Suction Only Mode), ask for
Stretch Belt - HOOVER
® part No. 38528058 or
AH20080.
If desired, additional belts can be purchased at
Hoover.com or 1-800-944-9200
F
IMPORTANT
Rotate brushroll manually to make sure belt is
not twisted.
belt
(continued)
13
4.29
Actual model may vary from images shown.