Hoover Vacuum Cleaner - Manual (Page 10)

10
cyclonic filter assembly: how to clean
Remove dirt cup as described in Fig. 4.3.
4.9 Twist filter assembly (A) counterclockwise.
Remove assembly from dirt cup.
4.10 Dirt and debris can be cleaned from the filter
assembly with the Dusting/ Upholstery Tool.
4.11 Place the filter assembly on the dirt cup,
aligning (3) tabs (A) on filter with (3) slots on dirt cup
(B) and twist it clockwise to secure into position.
4.12 The Hoover ® emblem and center lines on the
dirt cup should align on the front of the dirt cup (C)
if assembled correctly.
Replace dirt cup as described in Fig. 4.5.
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
Do not use vacuum without dirt cup or filters
in place.
4.9 4.10
A
A
b
4.11
what to buy: carbon filter
Carbon Filter may need to be replaced more
often to maintain optimal odor absorbing
effectiveness. Additional filter is available at
Hoover.com or call 1-800-944-9200. Ask for
Hoover
® Part No. 902404001.
carbon filter : how to clean
(Available on select models only).
Your Carbon Filter is located on the underside of
the Filter made with HEPA media.
IMPORTANT
DO NOT RINSE OR WASH the Carbon Filter.
4.8
4.8 With fingers in slots, pull filter frame (A)
straight out. Hold filter over a trash receptacle
and tap out dirt and debris.
Slide back into position on vacuum.
A
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug vacuum before servicing. Do not use
vacuum without dirt cup or filters in place.
what to buy: filter Made with hepa Media
When used and maintained properly, your Filter should not need replacement
within the warranty period. If desired, additional filter is available at Hoover.
com or call 1-800-944-9200. Ask for Hoover
® Part No. 303172001.
IMPORTANT
DO NOT RINSE OR WASH THE FILTER MADE WITH HEPA MEDIA.
filter Made with hepa Media: how to clean
4.12
C
Actual model may vary from images shown.