Hitachi VT-FX630A - Manual (Page 13)

13
Switch the RF Channel
When the VCR is on, its video signal can come into your TV on either channel 3 or channel 4. You need to select
the appropriate channel.
• When the power is turned on, press the POWER button to turn it off. Press the PLAY button on front of the
VCR. The POWER indicator will light up and the VCR indicator will flash. Press the CHANNEL
button
alternates between channel 3 and channel 4. The VCR will stop flash. If within 30 seconds, the CHANNEL
button not been press, the VCR will terminate the selection of RF Channel.
ADVANCED CABLE HOOKUP -WITH CABLE BOX [F]
WITH THIS HOOKUP
YOU CAN...
• WATCH AVAILABLE CABLE CHANNELS
• RECORD AND WATCH THE SAME CHANNEL
YOU CAN'T...
• RECORD ONE CHANNEL AND WATCH ANOTHER
ALL CHANNEL SELECTIONS MUST BE MADE AT THE CABLE BOX.
BE SURE TO CONSULT YOUR CABLE BOX MANUAL FOR THE CABLE BOX OUTPUT CHANNEL.
Hookup F Illustration
............................................................................................................................................................