Harbor Freight Tools 94446 - Manual (Page 4)

SKU 94446 For technical questions, please call 1-800-444-3353. Page 4
Unpacking
When unpacking, check to make sure the item is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
Setup
Floor
Stapler
1/4”-18 NPT
For best service you should incorporate an oiler, regulator, and inline filter, as shown in the
diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor
Freight Tools.
1.
Wrap the Air Inlet (37) with pipe thread seal tape (not included) before threading it into
the Arm (30). Connect the 3/8” ID Air Source Hose to the Air Inlet (37).
note: If you are not using an automatic oiler system, before each use add a few drops of
Pneumatic Tool Oil to the airline connection. Add a few drops more after each hour of
continual use.
2. Set the air pressure on your compressor to between 60-125 PSI. Do not exceed the
maximum air pressure of 125 PSI.
3. Check the air connection for leaks. Disconnect from the air source.
REV 11/06