Harbor Freight Tools 94446 - Manual (Page 2)

SKU 94446 For technical questions, please call 1-800-444-3353. Page 2
Specifications
Air Inlet 1/4”- 18 NPT
Working Air Pressure 60-125 PSI
Maximum Air Pressure 125 PSI *
Magazine Capacity 80
Air Consumption 4 CFM @ 125 PSI
Cleat Size Range 1-1/2” to 2” L-head Nails
Staple Size Range 1” to 2” Flooring Staples
* the air pressure setting must not exceed job site regulations/restrictions. the air pressure setting must
not exceed 90 pSi when being used with work pieces that have a thickness of less than 1-3/4”.
Save this Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and precautions
Warning: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
read all instructions before using this tool!
Keep work area clean. Cluttered areas invite injuries.
observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids.
Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, extension cords, or air hoses.
Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
Use the right tool for the job. Do not attempt to force a small tool or attachment to do
the work of a larger industrial tool. There are certain applications for which this tool was
designed. It will do the job better and more safely at the rate for which it was intended. Do
not modify this tool and do not use this tool for a purpose for which it was not intended.
dress properly. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Protective, electrically nonconductive clothes and nonskid footwear are
recommended when working. Wear restrictive hair covering to contain long hair.
Use eye and ear protection. Always wear ANSI-approved impact safety goggles. Wear
a full face shield if you are producing metal filings or wood chips. Wear an ANSI-approved
dust mask or respirator when working around metal, wood, and chemical dusts and
mists. 1.
2.
3.
4.
5.
6.
7.
REV 11/06