Hoshizaki F-450MAH(-C) EN - Manual (Page 7)

7
II. Installation and Operating Instructions
WARNING
1. This icemaker must be installed in accordance with all applicable national,
state, and local regulations.
2. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,
it will not work properly.
• Remove the front panel to prevent damage when installing the icemaker. See "II.B.
How to Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specified on the nameplate.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and towards
you.
• Top Panel: Lift up at the front slightly, push rearward,
and lift off.
• Side Panels: Remove the screw. Slide forward slightly
and lift off.
Fig. 1
Top Panel
Front Panel
Left Side Panel
Right Side Panel