Hoover 53425 - Manual (Page 15)

2. Release worn belt from pulley.
3. Lift out rug agitator, remove old
belt and place new belt in groove of
rug agitator.
4. Replace agitator. On one end of
the agitator roll there is a raised metal
plate. Make sure that this end is
placed in groove on side of cleaner.
5. Place belt on pulley. Side of belt
nearer cleaner should be in line with
arrow on bottom of cleaner.
6. Replace metal plate. Place metal
knobs on front end of plate in wire
holders. Check to see that latches are
pushed back and will not be covered
by plate. Place plate in position and
latch securely.
14