Hoover S3083-030 - Manual (Page 6)

TO CONNECT AND REMOVE HOSE
To connect hose, insert hose into opening of cleaner
lining up the arrow on the hose with the dot on the
cleaner. Turn the hose clockwise until it lines up
with the bar on the cleaner and latch locks into
place.
When the hose is attached properly, the hose cord
plug will reach to the receptacle on the cleaner.
Insert the plug firmly and as deep into the
receptacle as possible.
To disconnect hose, depress latch away from hose
connection opening in cleaner. While holding latch,
turn the hose counterclockwise until the arrow
lines up with dot on the cleaner.
HOW TO CONNECT THE
‘POWERMATIC’ NOZZLE
1. Attach Powcrmatic nozzle to the end of the ex-
tension wand. Be sure the nozzle is locked in place.
To release, press down on the center of the white
plastic spring latch and remove nozzle.
2. Position cord in cord clips on extension wands.
3. To attach the hose and extension wands, rotate
the plastic latch ring to accept the button projec-
tion on the extension wands.
Push the handle over the wand so that the button
projection fits into the slot. Turn the outer ring on
the handle to lock the handle and wand in place.
5