haier 50FREE-3B - Manual (Page 3)

Names of the par ts
Adjustable foot
Adjustable foot
film
Water inlet valve
Water-absorption
gasket
Top lid
Control
panel seat
Lint filter
Inner tub
Pulsator
Control
panelfilm
Cabinet
Power
cord
Handle
Drain
hose
Back
cover
Base
Hook
Out tub
cover
Fixed foot(3 pcs)
Inner cover
components
The pulsator pauses during water
inlet in wash and rinse.
It is to avoid splashing during water inlet
There may be some water flowing out of the
drain hose in the first use of the machine. It is the water remained performance inspection
by the factory.
Common phenomena
Phenomena Explanation
The spinning is intermittent when it starts.
Select spin program, but it does not work.
Balance the laundries to avoid slanting.
The program is setting the drain time , certain
period is needed before it starts spinning.
The safety switch acts, and the
spinning cannot work. The
digitron displays E3.
The water filling does not work, or is
slow, the digital displays E4.
The drainage cannot work, or is too slow.
The digitron displays E1.
It stops running in midway. The digitron
displays E2. The top lid is not closed. Close the top lid.
Is the drain hose hang up to suitable
height?
Is the drain hose blocked?
Hang up to suitable height . Open and close the
top lid once.
Clean the foreign material. Open and close
The top Lid Once.
Are the laundries put slantingly?
Is the machine slanting? Reorder the laundries. Close the top lid.
The machine will start running after 10
seconds of being placed horizontally.
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
Is the drain hose hang up to suitable
height?
Open the water tap. Open and close
the top lid once.
Clean the water inlet valve then open
and close the top lid once.
Open and close the top lid once.
Hang up to suitable height .
Phenomena The reason How to settle
Trouble-shooting answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
The water level sensor is bad. Please contract the after-sales
service department
Is the machine slanting?
Are the laundries put slantingly in spinning?
Are there any foreign materials?
Is the jointer of water
inlet hose loose or awry?
Adjust the machine to be even
Reorder the laundries and close the top lid.
Remove the foreign materials.
Fasten the jointer properly. The water tap leaks
The digitron displays F1.
There's abnormal sound
inside the machine
The machine does
not act
Not wash
Not spin
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset position? Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat? Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
16 1
Meaning and description of the symbols
Contents marked with that symbol are actions forbidden
to perform. Performing of those action may result in
damage of the machine or influence the personal safety of
the users.
Contents marked with that symbol are related to the
safety of the product and the personal safety of the users.
Please operate in strict conformity to the contents.
Warning sign
Forbidden sign