Husqvarna 395XP - Manual (Page 37)

English – 37
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
Bar Chain
Length, inch Pitch, inch Max nose radius
18-28 3/8" 11T Husqvarna H42, Oregon 73LP / 73LG / 73V
18-28 3/8" ATM 1,33” Husqvarna H42, Oregon 73LP / 73LG / 73V
0,050"/1,3 mm - 72LP 72LG 72V
0,058"/1,5mm H42 73LP 73LG 73V
0,063"/1,6 mm - 73LP 73LG 73V
!
WARNING! This chain saw model is capable
of severe kickback that could result in
serious injuries to the user. Do not operate
this saw unless you have extraordinary
cutting needs and experience and
specialized training for dealing with
kickback. Saws with significantly reduced
kickback potential are available. Always use
the safest saw and cutting equipment
applicable to your cutting need.