haier HWM90-0566 - Manual (Page 7)

5 12
b
1.Push "power" button to switch on the power
Power
Program
2.Push "program" button to select suitable
full-auto program
After the power is switched on, "normal"is automatically set. To select other full-auto program, please
push the "program" button till the corresponding indicator is on. Refer to the "Program button" on Page 11.
E.g. Set to "Quick wash" program for small quantity of laundries with light soil. The drainage shall be smooth with the drain hose.
1. The height of the drain hose shall be less than 10cm,
or the drainage will not be smooth, and cost such long
time that the machine may stop at mid way.
2. Do not step on or press the drain hose.
4. If extra drain hose is needed, please make separate
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed
1.5m.
3. If the drain hose is too long, cut it at mid point. To make
smooth drainage, cut the front end of the hose slantingly.
Usage the drain hose
5.If the extra hose is too long, cut it either at A or at B.
How to change the direction of the drain hose
Steps of using the operation buttons and
description of the steps
Remarks: in order to make sure of the correct of installation, it is suggested to change the direction of the drain hose
with our company serviceman .
Drain hose support
Drain hose
Drain bushing Drain bushing
drain outlet protecting
cover
Drain bushing
Drain hose fixing
clamp
Cabinet
Inner Outer
Push
Push
Take down
Figure 1 Figure 2
Figure 3
Figure 4 Figure 5
Figure 6
2.Put down the drain hose Take off the drain hose
frame as indicated in Figure 1.Take the drain hose into
the cabinet
then nip the drain fixing clamp to make
it deviated from the clip the other hand is used to put
down the drain bushing as indicated in Figure 2 3.
1.Dismantle the rear cover of the washing machine. 3.Dismantle the drain outlet protecting cover at the other side,
(the way is the same as the drain bushing),then install the drain
bushing, as indicated in Figure 4.
4.Extend the drain hose from the other side. Fix the drain hose
with drain hose frame onto the cabinet, as indicated in Figure 5.
5.Install the drain outlet protecting cover to the other side,
as indicated in Figure 6
Soak
6
•
•
••
•
•
•
•
•
5
•
Wash
Rinse
Spin Reserve
Water
level
Water
level
Program
Tub
dry
Tub
dry
Power
Standard
Fibre
Cotton
Woollen Woollen
Normal
Posthaste Posthaste
Quick
Jean
Tub dry
Push the "SOAK", "WASH", "RINSE" OR "SPIN" button to select suitable procedure.
Soak
Wash
Rinse
Spin
After switching on the power, the washing machine will set to common program including"wash, rinse,
spin "automatically. To select other procedures, push the "SOAK", " WASH", " RINSE" or "SPIN"
button to select the time of soak, wash and spin, and the times of rinse. After switching on the power,
if you push one of the button among "WASH", "RINSE"and"SPIN", the digitron of the former
procedures will turn off automatically. The former procedures will not run. For instance: after switching
on the power. If you push the "SPIN"button first, it will execute spin singly after starting.